Owner`s manual

Page 20
DV 42 Indoor Gas Fireplace
Installation
Section 7: Installing and Removing the Door
The DV 42* doors are removed in a few simple steps. Follow these below to remove
the horizontal access panel, unlatch the door buckles and remove the door. Replace
in reverse order.
Figure 26a. Locate the door buckles. (Both sides typical)
Door Latch Hook
Door Latch Slot
Hand-hold
Release the Door Buckles
Figure 26. Removing and installing the horizontal access panel
Locate the Door Buckles
Figure 26b. Door Buckle Tool
1
Step 4:
Firmly grasp hand-hold end of
door buckle tool and place the
machined end in the slot under
door frame as shown.
Figure 26c.
Step 2:
Step 3:
Step 1:
Remove the horizontal cover by placing
ngers in each nger hole, pushing
away from you and lifting the panel
out. Place it aside during maintenance
or cleaning.
Install in reverse order.
Installed Gas
Valve Cove
r
Finger Hole
Remove the Horizontal Access Panel
To install the door, hook the top edge of the door frame into place. Lower the door
into position and follow the previous steps shown in reverse order.
Installing the Door
2
Step 5:
Ensure the tool is rmly in the
lower end of the slot, as shown,
then pull toward you.
Caution! Hold the tool securely.
3
Step 6:
Pull hard if necessary to release
the spring tension.
Caution! The latch springs back
with force. Hold the tool securely.
4
Step 7:
Remove the tool from the latch
slot. Ensure the latches are hanging
freely and the hook end is released
from the bottom of the door.
Repeat all four steps for the
remaining latches.
Figure 26d.
Figure 26e.
Figure 26f.
Step 8:
Grasp the door on either side about midway and lift the door carefully up and
away from the front of the replace. See Figures 26g.
Place the door aside in a safe place while maintenance and/or cleaning is
being performed.
Figure 26g. Removing and installing the glass doors. (Both sides typical)
Removing the Door