Owner`s manual

Page 23
DV 42 Indoor Gas Fireplace
Operation
To Turn O Gas To Appliance:
1. Turn o remote switch.
2. Remove the lower Horizontal access panel.
3. Turn the incoming gas control valve to "O".
4. Replace the lower horizontal access panel.
with American Flame Electronic Ignition
For Your Safety - READ BEFORE LIGHTING:
Proame SIT Electronic Ignition
Lighting Instructions:
C. Use only your hand to push in or turn the gas control knob. Never use tools.
If the knob will not push in or turn by hand, don't try to repair it, call a qualied
service technician. Force or attempt to repair may result in a re or explosion.
D. Do not use this appliance if any part has been under water. Immediately
call a qualied service technician to inspect the appliance and to replace any part of
the control system, and any gas control which has been under water.
A. This appliance is equipped with an ignition system that lights the pilot burner
automatically. Do not attempt to light the pilot by hand.
B. BEFORE LIGHTING smell all around the appliance area for gas. Be sure to smell
next to the oor because some gas is heavier than air and will settle on the oor.
What To Do If You Smell Gas:
• Do not try to light any appliance.
• Do not touch any electrical switch; do not use any phone in your building.
• Immediately call your gas supplier from a neighbor's phone. Follow the gas
supplier's instructions.
• If you cannot reach your gas supplier, call the Fire Department.
1. STOP! Read the safety information above on this label.
2. Remove the lower horizontal access panel.
3. Turn Incoming gas valve to the ON" position.
4. Wait 5 minutes to clear out any gas. If you smell gas, STOP! Follow "B" in the
safety information above on this label. If you don't smell gas, go to the next
step.
5. Turn wall switch "ON".
6. If the replace does not light, the System will cycle through two trials, (one
minute audible clicking, thirty seconds of silence, and then another one minute
of audible clicking).
7. After completion of the information in the Troubleshooting section, Repeat
step 5.
8. If the system will not function correctly, follow the instructions "To Turn O Gas
To Appliance" and call your service technician or gas supplier.
EV1 (Pilot
burner)
EV2 (Main
burner)
Pilot Adjust Screw
Lockout Reset Key
Diagnostic Terminal
Power
Command (Wall
switch)
Pilot Sensor
Igniter
Ground
EV1 (Pilot burner)
EV2 (Main burner)
Gas "Out"
Gas "In"
Incoming Gas
Line, Shut-o
Valve
To replace Main
burner
Models
DV 42 E
If the information in these instructions is not followed exactly, a fire or explosion may
result causing property damage, personal injury or death.
WARNING