Installation manual
42
OPERATING the FIREPLACE
Element4 Gas Fireplaces EuropeanHome.com
Note: The system shuts o the appliance completely if there is no change in the ame height
for 5 days.
Setting °C/24 Hour or °F/12 Hour Clock.
Press OFF andÈto toggle between °F/12 hr and °C/24 hr clock.
Setting the time.
Simultaneously press theÈand
Çbuttons, the display now ashes.
PressÇto set the hour andÈto set the minute.
Press OFF to return to manual mode.
Igniting the Appliance.
On the remote control, simultaneously press and hold the OFF andÇbuttons.
An acoustic signal indicates that the start sequence has begun.
The electronic system then checks that the main gas is owing and ignites the main burner;
this may take up to 20 seconds.
NOTE: During start-up, the MANUAL knob on the gas valve cannot be in the MAN position. See
Figure 47.
Changing the Mode of Operation.
Briey pressing the SET button changes the mode of operation in the following order:
Man - Temp - Temp - Timer - back to Man
Man - Manual Flame Height Adjustment.
UP
DOWN
BEFORE THE FIRST FIRE
1. Make sure all construction materials have been removed from inside and around the replace.
2. Conrm the proper placement of the burner media.
3. Conrm that the controls are properly connected.
4. Check the gas supply for leaks.
5. Close and properly clamp the glass panels.
6. Check that the venting is unobstructed and in proper working condition.
USING THE REMOTE CONTROL ELECTRONIC IGNITION SYSTEM
OFF
SET
PAIRING THE REMOTE AND RECEIVER (Resetting the System)
The remote control must be paired to the receiver prior to rst use. This is done as follows:
1. Press and hold the receiver reset button (Figure 45) until you hear the second of two beeps. After the second beep release the
reset button and,
2. within twenty seconds, press and hold the È button on the remote until you hear the second of two beeps. Release the È
button.
Figure 45. Receiver
RESET BUTTON
Figure 46. Remote Control