Installation manual

45
GLASS CLEANING
Element4 Gas Fireplaces EuropeanHome.com
REMOVING AND CLEANING THE GLASS
Step 1.
Remove all of the trim pieces (magnetically attached) from the
replace. See Figure 49. The Tenore has two glass panels, therefore,
twice the number of trim pieces. There is no top trim on either
replace. The trim pieces are held rmly in place with magnets and
will simply lift out. The bottom (horizontal) trim pieces are at the
lower edge of the glass panels and the side (vertical pieces) are
where the glass meets the wall.
Step 2.
The glass panel is held in place by a gasketed glass clamp on the left
and right ends and a rope gasket along the bottom edge. Remove
the retaining bolt(s) holding the glass clamps and then remove the
clamps. See Figure 50. Gently pull the rope gasket from its channel.
Step 3.
Securely attach a vacuum glass clamp to the glass approximately
24”/600 mm from either end and lift the glass up into the clearance
notch.
With the glass panel raised into the upper rail, swing the lower edge
of the glass panel out towards the room and gently lower the glass
towards the oor until it clears the replace. See Figure 51.
Step 4.
Repeat Steps 2 and 3 for the other glass panel, if present.
REMOVING THE GLASS
• No. 2 Phillips screwdriver (not included)
• 2 vacuum clamps (included)
TOOLS REQUIRED
The glass panel(s) are held in place by two gasketed clamps (one on
either side with two bolts each) and a rope gasket at the lower edge
of the glass. These instructions require two technicians and will
show you how to remove and install the glass panel(s).
Please read these instructions completely before proceeding.
OVERVIEW
Figure 49
Side Trim
Bottom Trim
Figure 50