Installation manual

46
GLASS CLEANING
Element4 Gas Fireplaces EuropeanHome.com
The glass panel(s) should be installed in reverse order of their removal.
Step 1.
Securely attach the two vacuum glass clamps, each approximately
24”/600 mm from either end. Lift the glass panel up into the upper rail and
swing the lower edge of the glass panel against the rebox gasket. See
Figure 51. Set the glass clamps into place and hold them loosely into place
with a retaining bolt. DO NOT tighten the retaining bolts yet.
Step 2.
Ensure that the glass is at against the rebox gasket and centered on the
rebox.
Step 3.
Center the rope gasket on top of the gasket channel (in front of the lower edge of the glass.) While holding the center in place,
gently stretch the gasket while laying it into the gasket channel, left and right. Press the gasket down into the length of the gasket
channel. See Figure 52.
Step 4.
Hand tighten the bolts onto the glass clamps. Tighten the bolts ¼ turn further.
Step 5.
While ensuring that the glass panels are tight and square to each another, tighten the retaining bolt(s) on each clamp NO MORE
THAN ¼ TURN.
INSTALLING THE GLASS
CLEANING THE GLASS
The glass should be cleaned as necessary with a replace glass cleaner.
We recommend Stove Bright® Gas Appliance Glass
Cleaner by Forrest Paint Co. It is available through your retailer.
Follow the instructions for use and do not clean the glass when it is hot!
If the glass becomes coated with deposits which cannot be removed it
must be replaced.
Figure 51
Upper Rail
Gasket
Glass
Left
Side
Trim
Left
End of
Rope
Gasket
Figure 52
Gasket
Channel