Specifications

Document ID: 44080001 Rev: A Technical Support: 1-800-626-6912 Page 11 of 28
INSTALLATION INFORMATION MASSAGE CHAIR
Install seat track onto shell base using:
• 5/16 -18 x 3” bolt (Qty 4)
• 8M flat washer (Qty 8)
• 5/16 nut with nylon lock
• ½” open end wrenches or sockets
Install seat cushion on seat track using:
• Wing nuts (Qty 2)
Install seat back (this is heavy and may require two people to install) using:
• Alignment pins
• 3mm allen wrench.
Lay the seat back face down on the seat cushion. Align holes on seat track and side of seat back and
push the longer end of the pin in (with respect to the dimple in the pin) until the dimple in the pin is
aligned with the set screw hole. Insert set screw and tighten to hold pin in place.
Tip the seat back up and connect the bottom of the seat to the linear actuator using:
• Clevis pin
• Locking key
Electrical connections:
• Connect the wires from the seat back to the wires from the seat track.
o White two position connectors
o White four position connectors
o Black two position connectors
• Remove back panel on shell. Plug the 120vac wire into the power strip located inside.
• When wires are connected, bundle and zip tie to avoid pinching during seat movement.
• Connect remote to the connector located half way up the seat back.
• Verify power switch is on (located on the side of the seat back)
Install arms using
• Flat washer
• Lock washer
• Cap nut
• 15mm socket