Specifications

Document ID: 44080001 Rev: A Technical Support: 1-800-626-6912 Page 12 of 28

INSTALLATION INFORMATION PLUMBING

Note: Failure to comply with federal, state or local codes and ordinances will result in warranty being null and

void.

This pedicure spa installation must comply with all mandatory “state” or “local codes” for all plumbing and

electrical codes. A licensed plumber and licensed electrician must make the utility connections to this spa.

It is mandatory in some states such as Massachusetts to install additional backflow protection (reverse

backflow) on the Hot and Cold water supply lines. Check valves are standard on the Elle Spa. If a state such

as Massachusetts requires additional protection it is the owners responsibility to comply.

Location and Support

Select a level floor location for installation. The floor structure beneath the pedicure spa must be capable of

supporting the occupied unit. For the seat back to fully recline, the spa base must be mounted at least 25 inches

from the wall as shown below:

WATER SUPPLY

• All plumbing connections must conform to local codes.

• Water pressure must be 30 to 80 PSI for the sprayer to operate correctly.

• Maximum operating water temperature should not exceed 105

F (41

C) and the maximum supply

water temperature should not exceed

120° F (49° C). (In Massachusetts, the maximum supply

water temperature should not exceed 130

F (54

C)). Adjust the hot water heater accordingly.

• For hot and cold water supply fittings and power drain fitting locations, see figure 1 below.

• Carefully connect the incoming water supply lines to the appropriate fittings located on the back of the

pedicure spa. Shut-off valves are recommended.

**Note: See local and state codes as to what type of drain connection is required to be made.

Backflow Protection Devices for Faucets with Side Spray: Check valves comply with ANSI/ASME A112.18.3M,

A112.18.1M, and CSA B12

Neoperl

DW15GF check valves are

located in the hot and cold water

lines.

The drain line must be a minimum of

3/4” inside diameter from Spa to wall

connection for basin to drain

properly.

Note: Not using the supplied

bulkhead fittings will result in NO

backflow protection. Check your

Local & State plumbing codes for

additional backflow requirements.

Any additional requirements are the

responsibility of the owner of the unit.