EUROPEAN TOUCH - LIMITED CONDITIONAL* WARRANTY European Touch Holdings, Inc. ("European Touch") conditionally warrants your pedicure spa (the "Pedicure Spa") in accordance with the terms and conditions set forth below for a period of one (1) year commencing on the original date of shipment of the Pedicure Spa to you. The warranty only applies to the Pedicure Spa's original end-user owner or customer (the "Customer").
• • • chrome and plumbing components and will void the limited warranty on those parts. European Touch recommends that you thoroughly read labels and use sanitizing products void of these chemicals. Use of this pedicure spa for functions it was not created for, including, but not limited to, ionic detox or any process that operates by reverse electroplating; this use will destroy plated parts and void the warranty.
OWNERS MANUAL For Omni Spa IMPORTANT INFORMATION Serial Number: Work Order Number: Installed by: Installation Date: The serial number and work order number are located above the water connections at the rear of the unit.
TABLE OF CONTENTS EUROPEAN TOUCH - LIMITED CONDITIONAL* WARRANTY ................................................................ 2 IMPORTANT INFORMATION ............................................................................................................. 4 TABLE OF CONTENTS ................................................................................................................... 5 INTRODUCTION .................................................................................................
INTRODUCTION Thank you for selecting EUROPEAN TOUCH, the leading designer, manufacturer, and marketer of pedicure spas in North America. The Omni Spa (herein referred to as pedicure spa) is an innovative pedicure spa that has been designed to serve you dependably for many years. Please take time to thoroughly read this entire manual before installation and use.
DANGER 1. Never use pins or other metallic fasteners with this appliance. WARNINGS 1. WARNING: RISK OF ELECTRIC SHOCK; do not permit electric appliances (such as a hair dryer, lamp, telephone, radio, or television) within 1.5M (5 feet) of this hydromassage bathtub. 2. CAUTION: Test the ground fault circuit interrupter protecting this appliance periodically in accordance with the manufacturer’s instructions. 3. Temperatures sufficiently high to cause burns may occur regardless of the control setting. a.
IMPORTANT REQUIREMENTS EUROPEAN TOUCH requires that you contact your local, licensed plumber and licensed electrician to install your new pedicure spa. Installation must be in compliance with your local and state building codes. Your pedicure spa cannot operate efficiently or safely unless it is provided with adequate electrical power, sufficient water pressure, proper water temperature, and required drainage capabilities.
PEDICURE SPA SPECIFICATIONS Hot and cold water supply lines required (hot and cold shut offs may be installed under pedicure spa base) SHIPPING INFORMATION Spa ships in three separate boxes on one pallet. One box contains the spa base, one contains the chair, and one contains the chair arms. Weight: 225 lbs. (102 kg) - includes spa, carton, pallet (estimated) Shipping Dimensions: 55”L (140cm) x 36.
COMPONENT REFERENCE Footrest Pad Geni-eye Pipless Jet On/Off Power Drain Switch (Optional) On/Off Motor Air Switch Water Faucet Fill Handle Overflow Handle Sprayer Drain Plunger Note: Pressing with finger nails, rather than the pads of fingers, will damage the on/off switch and will not be covered under the warranty. DO NOT PLUG JET HOLES WITH ANY ITEMS, INCLUDING TOES.
INSTALLING THE CHAIR ON THE BASE 1. Attach the swivel to the bottom of the chair using the supplied cap screws and lock washers using the supplied hex wrench. 2. Attach the chair/swivel assembly to the base using the (4) star knobs. Two people are recommended to lift the chair into position. 3. Attach the armrests using the supplied nuts and lock washers using the supplied wrench. 4. Place the transformer on the wooden base and plug the chair into the barrel plug. 5.
REMOVING AND REPLACING LOCKING CAP Check your state and local regulations for cleaning procedures. Links to your state boards can be found on our web site, at www.europeantouch.com. 1. Place the cap into position and turn clockwise until the locking pin is at the top right corner of the motor mount. 2. To remove cap the use of a tool is required. 3. Insert tool shown in diagram (below) adjacent to locking pin. 4. Gently turn the cap counter-clockwise to remove cap.
OPERATING INSTRUCTIONS GETTING STARTED 1. Check that the waste & overflow control valve is closed. 2. Open the faucet handle and fill tub with water until the water level is 1” above jets. 3. Press on/off air button switch to start the jets. 4. Adjust the air control to desired flow. The jets system must not be turned on when the system is dry, as damage may occur. Such damage is not covered by warranty.
ROLLER / VIBRATION MASSAGE SYSTEM Turning On\Off 1. Press POWER button to turn ON. 2. Repeat Step #1 to turn OFF. Initiate roller massage in seat back 1) Press the membrane switch under “ROLLER”. 2) Massage will automatically turn off in 20 minutes. Initiate seat vibration massage. 1. Select vibration zone Lower Back, Upper Back or both. 2. Choose appropriate strength, speed vibration, along with function A = Wave B = Pulse C = Continuous Selecting Massage Mode Cycle Time 1.
PIPE-FREE SPA CLEANING AND DISINFECTING PROCEDURES Always check with your state board for required cleaning and disinfecting procedures. It is extremely important to clean and disinfect your pedicure spa after each pedicure, after the last pedicure of the day, and once a week for overnight cleaning. Regular cleaning will help keep your pedicure spa in good working condition. Proper and continuous cleaning will kill harmful bacteria and germs that can cause infection.
PEDICURE SPA CLEANING LOG SHEET “Sample” Pedicure Spa # Date Document ID: 10080000 Time Initials Rev: B After Client End of Day Technical Support: 1-800-626-6912 Weekly Page 16 of 20
REPLACEMENT PARTS SPA ASSEMBLY Document ID: 10080000 Rev: B Technical Support: 1-800-626-6912 Page 17 of 20
ITEM NO. PART NUMBER DESCRIPTION QTY. 1 1016010X(0-1,9) CHAIR ROLLER BLACK 1 2 10040002 REMOTE WAND 1 3 10130000 FAUCET SPRAYER ASSEMBLY 1 4 10040000 SWITCH MEMBRANE DRAIN 1 5 39150007 ASM MOTOR EUROPEAN TOUCH SYSTEM 1 6 10130001 BUTTON AIR VALVE 1 7 10020000 SWIVEL 1 8 14040151 CABLE MODULAR BUTTON 1 9 101600XX(00-02,20-22) OMNI SPA 110V/220V BASE WHITE/BLACK/BONE 1 10 10000050 FOOTREST OMNI 1 11 10150001 12 10150000 13 30010218 COUPLER 1.50” TO 1.
HISTORY AND NOTES Document ID: 10080000 Rev: B Technical Support: 1-800-626-6912 Page 19 of 20
EUROPEAN TOUCH 8301 W. Parkland Court Milwaukee, WI 53223 Phone Number: Toll Free: Fax: Web Site: Email: 1-414-357-7016 1-800-626-6912 1-414-357-6360 www.europeantouch.com info@europeantouch.
