Specifications

Document ID: 10080000 Rev: B Technical Support: 1-800-626-6912 Page 12 of 20
REMOVING AND REPLACING LOCKING CAP
Check your state and local regulations for cleaning procedures. Links to your state boards can be found on our web site,
at www.europeantouch.com
.
1. Place the cap into position and turn clockwise until the locking pin is at the top right corner of the motor mount.
2. To remove cap the use of a tool is required.
3. Insert tool shown in diagram (below) adjacent to locking pin.
4. Gently turn the cap counter-clockwise to remove cap.
PEDICURE PRODUCT GUIDELINES
Because there are so many different products on the market, it is difficult to list all of the pedicure products that
are safe to use in our pedicure spas. However, the following guidelines can be used:
• It is your responsibility to understand and follow your state’s regulations regarding product cleaning and
disinfecting requirements.
• Do not use any products containing a foaming agent; this will cause excessive foam.
• It has been determined that products containing non-dissolving abrasives (such as sand and sea salts)
will not harm the internal component structure of your pedicure spa as long as the entire EUROPEAN
TOUCH cleaning requirements are followed without deviation.
• Oil based products may be used in your pedicure spa as long as the cleaning requirements are met.
• Please use pedicure products and cleaning solutions in accordance with each manufacturer's
directions.
EUROPEAN TOUCH pedicure spas will give you many years of service as long
as proper precautions, precise cleaning, and operating instructions are followed.
It is the responsibility of the pedicure spa user to properly clean and maintain
the pedicure spa.
Geni-eye
Pipeless Cover
Cover Removal
Tool