User manual

PRI – Cellular Multi-Cell Gateway
7 / 54
 Optional Task - Configurations
In order to operate the system and start making calls , a certain setup should be performed.
Refer to the following chapter s that match your configuration need s:
Chapter 3.2: Management via Ethernet interface Connection
Chapter 4: Configuration - Defining Groups of Ports
Chapter 5: Configuration - Port and SIM
Chapter 5.1: Configuration – Define Dial Settings for Each Port
Chapter 5.2: Define Work Mode for Port
Chapter 5.3: Configuration – SIM Card Settings
Chapter 6: Configuration - ISDN Connection Settings
Chapter 6.2: Configuration – B-Channels, Ports and Prefixes
 Optional Task - Monitoring calls
The PRI Management MS -Windows Application enables you to monitor calls in real time.
It is recommended that the Management Application PC will be connected via IP , in order
to enable flexible and continues connection with the monitored system.
Refer to "Chapter 7: Monitoring Calls" for further explanations.
 Optional Task - Making usage reports
The PRI Management MS -Windows Application enables you to generate call reports and
export the report files for additional analysis. It is recommended that the Management
Application PC will be connected via IP, in order to enable flexible and continues
connection with the monitored system.
Refer to "Chapter 8: Generating Call Reports" .
 Optional - Test call between office phone and c ellular phone
Make a test call from your office phone to a cellular c ell phone. This will enable you to
trace problems in your settings and will guide you in finding the root cause of your
operational error if any, and to overcome operational problems. If still , after all the
guidelines and sub tests completed , you could not trace th e problem, you are referred to
"Chapter 10: Operational Test". In this chapter we'll m ake handset test call, which is
mainly used to check the operation and c ompatibility of the Multi -Cell system with the local
cellular network.