User's Manual
Table Of Contents
- Intended audience of this document
- How to get technical support
- Trademarks
- Revision history
- How to get started
- Contents
- 1 Safety-related information
- 2 Consignes de sécurité
- 3 Technical terms and graphical symbols
- 4 Termes techniques et symboles graphiques
- 5 Product Overview
- 6 Certifications
- 7 BoltAIR 20-31 interfaces
- 8 Product installation and power supply
- 9 Eurotech Everyware IoT
- 10 Product maintenance
- Notes
BoltAIR 20-31 User's manual EN 8 Product installation and power supply
© 2022 Eurotech SpA - Via Fratelli Solari 3/A - 33020 AMARO (UD) - Italy
Code: BTAIR-20-31-11_MAN_EN_1-3
Revision: 1-3 2022.07.28
49 / 60
8.2 How to install the product on a DIN Rail
Prerequisite: Make sure that the DIN rail is placed horizontally.
To install the product on a DIN rail, complete the following steps:
1. Position the product so that the upper side of the Mounting bracket hooks on the upper edge of
the DIN rail, see step 1
2. Push the product downwards against the DIN rail until the lower hooked side of the Mounting
bracket lock on the lower edge of the DIN rail, see step 2.
The product is now installed on the DIN rail.
8.3 How to remove the product from a DIN Rail
To remove the product from a DIN rail, complete the following steps:
1. Pull the lower hooked side of the Mounting bracket down so that the product is detached from the
lower edge of the DIN rail, see step 1
2. Lift the product upwards so that the upper side of the Mounting bracket is released from the upper
edge of the DIN rail, see step 2.
The product has now been removed from the DIN rail.