User's Manual
Table Of Contents
- Intended audience of this document
- How to get technical support
- Trademarks
- Revision history
- How to get started
- Contents
- 1 Safety-related information
- 2 Consignes de sécurité
- 3 Technical terms and graphical symbols
- 4 Termes techniques et symboles graphiques
- 5 Product Overview
- 6 Certifications
- 7 Main CPU Module interfaces
- 7.1 Main CPU Module connectors (vers: -11)
- 7.2 Main CPU Module connectors (vers: -21 and -31)
- 7.3 Main CPU Modules Interfaces
- 7.3.1 USB0 and USB1: USB 3.0 connectors specifications
- 7.3.2 DP: Mini DisplayPort specifications
- 7.3.3 ETH0, ETH1, ETH2: Gb Ethernet connectors specifications
- 7.3.4 PWR IN: Power IN connector specifications
- 7.3.5 Navigation system specifications
- 7.3.6 LTE cellular modem specifications
- 7.3.7 Wi-Fi and BT specifications (vers: -21 and -31 only)
- 7.3.8 MVB ESD+ (RX only or RX/TX) interface specifications (vers: -11 only)
- 7.3.9 Earth connection terminal specifications
- 7.4 Main CPU Module LED indicators
- 7.5 Main CPU Module Service Panel and Service Interfaces
- 8 BoltAIR 20-31 interfaces
- 9 BoltIO 20-31 interfaces
- 10 BoltSER 20-31 interfaces
- 11 Product installation and power supply
- 11.1 Introduction
- 11.2 How to install the product on a DIN Rail
- 11.3 How to remove the product from a DIN Rail
- 11.4 Mechanical specifications
- 11.5 How to supply power to the system
- 11.5.1 Power supply specifications
- 11.5.2 The Ignition Key (Key Signal)
- 11.5.3 Main CPU Module and Expansion Modules electrical interconnections
- 11.5.4 Power supply safety instructions
- 11.5.5 How to supply power and turn ON the product
- 11.5.6 How to turn OFF the system
- 11.5.7 How to trigger a hardware reset of the system
- 12 Eurotech Everyware IoT
- 13 Product maintenance
- Notes
6 Certifications BoltGATE 20-31 User's manual EN
6.1 Declaration of Conformity
Upon request, Eurotech can provide the product Declaration of Conformity. For more information, refer
to the Eurotech Technical Support (https://www.eurotech.com/en/support).
6.2 CE marking
This product is CE marked and complies with the essential requirements and other
relevant requirements of the directives reported in the following sections.
Eurotech does not approve the use of this product with equipment (for example: power
supplies, personal computers, etc.) that is not CE marked and that is not compliant with the
requirements specified in this User's manual.
6.2.1 Safety
This product complies with the standard EN 62368-1:2014 on the safety requirements in information and
communication technology equipment.
6.2.2 RoHS 3 compliance
This product complies with the following Directives:
l
Directive 2011/65/EU of the European Parliament and of the Council of 8 June 2011 on the
restriction of the use of certain hazardous substances in electrical and electronic equipment.
l
Commission Delegated Directive (EU) 2015/863 of 31 March 2015 amending Annex II to
Directive 2011/65/EU of the European Parliament and of the Council as regards the list of
restricted substances
6.2.3 Packaging and packaging waste
This product complies with the European Parliament and Council Directive 94/62/EC of 20 December
1994 on packaging and packaging waste.
6.2.4 Product disposal and recycling
This product, at the end of its life cycle, must be collected separately and managed in accordance with
the provisions of the Directive 2012/19/EU of the European Parliament and of the Council of 4 July 2012
on waste of electrical and electronic equipment (WEEE).
For more information, refer to: "The WEEE label" below.
6.2.4.1 The WEEE label
This symbol, placed on the product, indicates that the product at the end of its life cycle
must be sent to separate collection facilities for recovery and recycling.
Because of the substances present in the product, improper disposal can cause damage
to human health and to the environment.
For collecting and recycling information, refer to: https://www.eurotech.com/en/support.
32 / 98 © 2022 Eurotech SpA - Via Fratelli Solari 3/A - 33020 AMARO (UD) - Italy
Code: BTGATE-20-31_MAN_EN_1-6
Revision: 1-6 2022.07.28