User's Manual
Table Of Contents
- Intended audience of this document
- How to get technical support
- Trademarks
- Revision history
- How to get started
- Contents
- 1 Safety-related information
- 2 Consignes de sécurité
- 3 Technical terms and graphical symbols
- 4 Termes techniques et symboles graphiques
- 5 Product Overview
- 6 Certifications
- 7 Main CPU Module interfaces
- 7.1 Main CPU Module connectors (vers: -11)
- 7.2 Main CPU Module connectors (vers: -21 and -31)
- 7.3 Main CPU Modules Interfaces
- 7.3.1 USB0 and USB1: USB 3.0 connectors specifications
- 7.3.2 DP: Mini DisplayPort specifications
- 7.3.3 ETH0, ETH1, ETH2: Gb Ethernet connectors specifications
- 7.3.4 PWR IN: Power IN connector specifications
- 7.3.5 Navigation system specifications
- 7.3.6 LTE cellular modem specifications
- 7.3.7 Wi-Fi and BT specifications (vers: -21 and -31 only)
- 7.3.8 MVB ESD+ (RX only or RX/TX) interface specifications (vers: -11 only)
- 7.3.9 Earth connection terminal specifications
- 7.4 Main CPU Module LED indicators
- 7.5 Main CPU Module Service Panel and Service Interfaces
- 8 BoltAIR 20-31 interfaces
- 9 BoltIO 20-31 interfaces
- 10 BoltSER 20-31 interfaces
- 11 Product installation and power supply
- 11.1 Introduction
- 11.2 How to install the product on a DIN Rail
- 11.3 How to remove the product from a DIN Rail
- 11.4 Mechanical specifications
- 11.5 How to supply power to the system
- 11.5.1 Power supply specifications
- 11.5.2 The Ignition Key (Key Signal)
- 11.5.3 Main CPU Module and Expansion Modules electrical interconnections
- 11.5.4 Power supply safety instructions
- 11.5.5 How to supply power and turn ON the product
- 11.5.6 How to turn OFF the system
- 11.5.7 How to trigger a hardware reset of the system
- 12 Eurotech Everyware IoT
- 13 Product maintenance
- Notes
BoltGATE 20-31 User's manual EN 6 Certifications
© 2022 Eurotech SpA - Via Fratelli Solari 3/A - 33020 AMARO (UD) - Italy
Code: BTGATE-20-31_MAN_EN_1-6
Revision: 1-6 2022.07.28
33 / 98
6.2.5 RED compliance
This product complies with the Directive 2014/53/EU of the European Parliament and of the Council of
16 April 2014 on the harmonization of the laws of the Member States relating to the making available on
the market of radio equipment.
Modification statement
Eurotech does not approve any changes or modifications to this product by the user. Any changes or
modifications could void the user’s authority to operate this product.
6.2.5.1 Class II product and EU restrictions on 5 GHz Wi-Fi usage
According to Commission Decision 2000/299/EC of 6 April 2000, establishing the initial classification of
radio equipment and telecommunications terminal equipment and associated identifiers, the product
falls within the scope of Class II.
Due to EU restrictions on 5 GHz Wi-Fi bands the product is limited to indoor operation and can only be
operated in the frequency band 5150 MHz – 5250 MHz (U-NII-1) covering 20 MHz channels
(36,40,44,48), 40 MHz channels (38,46), and 80 MHz channel (42).
Dynamic Frequency selection (DFS) as master or subordinate is not supported by the product.
AT BE BG CH CY CZ DE
DK EE EL ES FI FR HR
HU IE IT IS LI LT LU
LV MT NL NO PL PT RO
SE SI SK TR UK(NI)
6.3 UKCA marking
This product is UKCA marked and complies with the relevant UK Statutory Instruments
and their amendments:
l
2017 No 1206 The Radio Equipment Regulations 2017
l
2012 No 3032 The Restriction of the Use of Hazardous Substances in Electrical
and Electronic Equipment Regulations 2012
Eurotech does not approve the use of this product with equipment (for example: power
supplies, personal computers, etc.) that is not UKCA marked and that is not compliant with
the requirements specified in this User's manual.