User's Manual
Table Of Contents
- Trademarks
- Intended audience of this document
- Revision history
- How to get started
- Contents
- 1 Safety instructions
- 2 Consignes de securite
- 3 How to receive technical assistance
- 4 Comment obtenir une assistance technique
- 5 Conventions used
- 6 Product overview
- 7 Regulatory information
- 7.1 CE compliance
- 7.2 FCC/ISED compliance
- 7.2.1 FCC marking
- 7.2.2 FCC compliance: Class B Digital Device
- 7.2.3 FCC restrictions on 5 GHz Wi-Fi usage
- 7.2.4 ISED Canada compliance
- 7.2.5 ISED Class B Digital Device Notice
- 7.2.6 Responsible parties: Canadian Representative contact information
- 7.2.7 RF Radiation Exposure Statement
- 7.2.8 Labeling information
- 7.3 Antennas List
- 7.4 RoHS 3 compliance
- 7.5 REACH compliance
- 8 Interfaces overview
- 9 Interfaces in detail
- 9.1 Wi-Fi and Bluetooth
- 9.2 Internal Cellular Modem
- 9.3 MicroSIM card receptacles
- 9.4 GNSS
- 9.5 USB 0, USB 1, USB 2
- 9.6 ETH 0, ETH 1
- 9.7 COM 0, COM 1
- 9.8 CAN 0, CAN 1
- 9.9 Earth connection terminal
- 9.10 Display Port
- 9.11 Digital I/O and Analog IN
- 9.12 Audio connector
- 9.13 TTL Serial Console
- 9.14 MicroSD card receptacle
- 9.15 RTC (Real Time Clock)
- 9.16 TPM
- 9.17 Watchdog
- 9.18 Accelerometer and Gyroscope
- 9.19 Programmable pushbutton
- 10 Eurotech Everyware IoT
- 11 Mechanical specifications and dimensions
- 12 How to install the product
- 13 Power supply. How to turn ON/OFF and reset the product
- 14 How to maintain the product
- Notes
DynaGATE 20-30 User manual Rev. 0-7 7 Regulatory information
7 REGULATORY INFORMATION
This section provides regulatory information for the DynaGATE 20-30 (hereafter referred to as "this
"product").
Upon request, Eurotech can provide the product Declaration of Conformity.
For details and more information contact the Eurotech Technical Support (see "How to receive technical
assistance" on page17).
7.1 CE compliance
7.1.1 CE marking
This product is CE marked and complies with the regulatory information reported in the
following sections.
Eurotech is not responsible for the use of this product together with equipment (for example:
power supplies, personal computers, etc.) that are not CE marked and not compliant with the
requirements specified in this document.
7.1.2 Safety
This product is compliant with the standard EN 62368-1:2014 on the safety requirements in information and
communication technology equipment.
7.1.3 Packaging and packaging waste
This product is manufactured in compliance with the European Parliament and Council Directive 94/62/EC
of 20 December 1994 on packaging and packaging waste.
7.1.4 Product disposal and recycling
This product, at the end of its life cycle, must be collected separately and managed in accordance with the
provisions of the Directive 2012/19/EU on waste of electrical and electronic equipment.
For details and more information:
l See: "WEEE compliance" below
l Contact the Eurotech Technical Support (see "How to receive technical assistance" on page17).
7.1.5 WEEE compliance
In compliance with the Directive 2012/19/EU of the European Parliament and of the Council
of 4 July 2012 on waste electrical and electronic equipment (WEEE), the symbol on the right,
shown on the product or within its literature, indicates separate collection for electrical and
electronic equipment (EEE) that has been placed on the market after 2005.
This product, at the end of its life cycle, must be collected separately and managed in
accordance with the provisions of the current Directive on waste of electrical and electronic
equipment.
Because of the substances present in the product, improper disposal can cause damage to
human health and to the environment.
For collecting and recycling information contact the Eurotech Technical Support (see "How
to receive technical assistance" on page17).
29 / 76