User's Manual

SYS-04240-23 User Manual 1-3 How to install the product
35 /
42
11.3 How to supply power to the product (turn ON/OFF the
product)
The SYS-04240-23 provides the Power connector on the rear side.
The product is protected against reverse voltage, surge and over-voltage.
NOTICE
• The SYS-04240-23 can be powered from batteries, using a voltage that fulfills the
required standards and the technical specifications
• Always apply all the required protection devices against over-currents in compliance
with the applicable standards.
11.3.1 Before supplying power to the product
Before supplying power to the product, complete the following steps:
1. Verify that the DC power source is turned OFF
2. Verify that the installation is made following all the required operating and safety
instructions.
11.3.2 How to safely connect power to the product
WARNING
ELECTRIC SHOCK HAZARD
Failure to supply power correctly or to follow all operating instructions correctly, may create
an electric shock hazard, which could result in personal injury or loss of life, and / or damage
the equipment or other property.
To avoid injuries and safely supply power to the product, complete the following steps:
1. Observe all the instructions for safety, installation, and operation
2. Make sure your hands are dry
3. Make sure that all the cables used:
a. Are in good condition before using them
b. Meet the product requirements and comply with the relevant standards and
regulations
4. Position cables with care. Do not position cables in places where they may be
trampled or compressed by objects placed on them
5. Make sure that the power-points and plugs are in good condition before using them
6. Do not overload the power-points and plugs
7. Make sure that the product maintains a proper grounding connection.
Always use the earth protection terminal to connect the product to an earth point in
the installation: see also "Earth Connection Terminal" page 27
8. Use a power supply that meets the product requirements and complies with the
relevant standards and regulations. In case of uncertainties, contact the Eurotech
Technical Support Team (for more information see "How to receive technical
assistance" on page 9)
9. Connect power after the installation of the system has been completed
10. Never connect or disconnect the cables with the system or the external apparatus
switched ON.