Installation guide

A
ccess Levels Installation and Operation Handbook
3-2
2
408 and 2404 Controller
SELECTING AN ACCESS LEVEL
Access to Full, Edit or Configuration levels is protected by a password to prevent
unauthorised access.
If you need to change the password, see Chapter 6, Configuration.
Access list header
Press
until you reach the access list header ‘ACCS’.
Press
Password entry
The password is entered from the ‘codE’ display.
Enter the password using or . Once the correct password
has been entered, there is a two second delay after which the lower
readout will change to show ‘PASS’ indicating that access is now
unlocked.
The pass number is set to ‘1’ when the controller is shipped from
the factory.
Note; A special case exists if the password has been set to ‘0’. In
this case access will be permanently unlocked and the lower
readout will always show ‘PASS’.
Press
to proceed to the ‘Goto’ page.
(If an incorrect password has been entered and the controller is
still ‘locked’ then pressing
returns you to the ‘ACCS’ list
header.)
Access to Read-only Configuration
From this display, pressing
and together will take you
into Read-Only Configuration without entering a password. This
will allow you to view all of the configuration parameters, but not
adjust them. If no button is pressed for ten seconds, you will be
returned to the Home display. Alternatively, pressing
and
together takes you immediately back to the Home display.