Operating instructions

Configuration
R M
OP1
OP2
Configuration
Link open =
operator level
Link closed =
configuration level
Figure 6.1.1 Configuration link/switch
Hardware configuration
It is important to note in the configuration of the instrument that the configuration parameters
possible for an output
(OP 1, OP 2 or AL 1) depend on the output module installed.
Depending on the output module, only certain configuration values may be selected. Figure
612.1 shows the possible combinations of configuration parameters with output module. Use
this table if re-configuring the instrument.
# = Permissible combination of configuration parameter and output module
Figure 6.2.1 :.Hardware configuration
6-2
808/847 & 809/849 installation and Operating Instructions