User guide

3216 User Guide Part No. HA027985ENG Issue 2.0 May 04
ENG
19
5.3 Pre-Configured Controller or Subsequent Starts
The controller will briefly display the quick codes during start up but will then proceed to operator level 1.
Note:- If the Quick Codes do not appear during start up this means that the controller has been re-configured in a
deeper level of access, as stated above, and the Quick Codes may no longer be valid. The controller will power up in
mode it was in prior to shutdown and you will see the display shown below. It is called the HOME display.
Measured Temperature
(or Process Value ‘PV’)
Required Temperature
(or Setpoint ‘SP’)
The OP1 beacon will be
on if output 1 is
configured for heat
and calling for power
In this view
the controller
is in AUTO
mode