Instruction manual

Instruction manual αlpha DO 2000
6
2.3.1 Display Overview
The LC display shows two alpha-numerical fields for parameters and measured values as well
as various mode and status indicators.
MEAS
SETUP
CAL
HOLD
°C °F
ERR
ATC
%
ppm
mg/l
13.0
Mode indicators:
MEAS: measurement mode
SETUP: Set-up mode
CAL: Calibration mode
Status indicator:
HOLD: Unit in “HOLD” mode
ATC: Visible in ATC (Automatic Temperature
Compensation) mode. Not visible in the Manual
Temperature Compensation mode. “ATC”
flashes if the temperature probe is faulty in its
ATC mode
ERR: Error indicator
2.3.2 Key functions
Key Description
Enter Calibration mode (requires access code)
Enter Set-up mode (requires access code)
Access sub functions (parameters) within a function group of Set-up mode
Confirm (store) set-up parameters and numerical values
Start/Confirm calibration in Calibration mode.
Select function group in the Set-up mode.
Set parameters and numerical values (if key is pressed continuously, the setting speed
increases).
Control the relays in MANUAL relay operation.
Returns to “Measurement mode” when both keys are pressed simultaneously.
Display limit values for SP1 and SP2 and settings for wash contact in AUTO relay
operation.
Toggle between RELAY A, RELAY B or Wash relay in MANUAL relay operation
Switch from AUTO to MANUAL relay operation (requires access code)