Instruction manual

Instruction Manual CyberScan PC5500/ 5000
97
To Set Sample ID#
When this option is active, each time you touch print on the Measure
screen the mV value along with the date/time/channel and the sample
ID# will be sent to data storage. You can manually enter an
alphanumeric identification number of up to 9 characters for any
sample, or you can have the meter sequentially number your samples
beginning at the number of your choice. You may also choose to
deactivate the sample ID#.
The conductivity Sample ID# is set the same way as previously
described in pH Setup. See page 44 for instructions.
To Select Conductivity Units
This screen allows you to select the units in which the meter will
report the conductivity measurement of your sample. You can choose
microSiemens/cm for conductivity or, ppt for Salinity pr, ppm for total
dissolved solids or ohm.cm for Resistivity. The current units are
displayed on the screen.
Access the Select Conductivity Units from the Conductivity Setup
screen. The current units are displayed on the screen.
Use the arrow keys to highlight the desired units.
Touch enter to accept these units and return to the Conductivity
Setup screen.
OR
Touch exit to return to the Conductivity Setup screen, without making
any changes.

The salinity scale is a measure of all salts, not just sodium chloride in
seawater.