Instruction manual

Instruction Manual CyberScan PC5500/ 5000
119
11 mV OPERATION
This mode is used to measure oxidation/ reduction potential
(ORP/redox), perform titration and to verify the function of the meter.
The mV measure function allows you to continuously monitor the mV
potential of the electrodes in use. This can be done in either absolute
or relative mV.
In the millivolts mode, the current millivolts output from the electrodes
being used is monitored and displayed on the screen. The meter will
continually monitor the millivolts reading in this mode and will not lack
onto a single reading. However, once the reading has become stable,
a stable message will be displayed. Remember to setup your mV
measuring mode parameters. Refer to pages 76-81for mV setup
instructions.
Measure
 Touch for Relative mV reading REL
REL
abs mV channel 1
0.0
J
anuary 15, 2002 11:11am
ID#
00000 ATC 25.0°C