User Guide

Instruction Manual CON 510

SETUP

P5.0: Mode of Calibration

Selection of Automatic or Manual Calibration

(only in Conductivity mode)

Selection of Single or Multi-point Calibration

SETUP

P6.0: Selecting cell constant

Selecting cell constant K: 0.1, 1.0, 10.0

SETUP

P7.0: Reset to factory defaults

Reset meter to factory defaults

7.2 P1.0: Viewing Calibration Data

This mode lets you recall previous calibration data of Conductivity/TDS. This is for

viewing only and no changes can be made.

1. From measurement mode, press SETUP key to enter into setup [SETUP] mode.

2. Use MI/▲ or MR/▼ to scroll through sub-menus until you view main-menu CAL

P1.0 on the display.

3. Press ENTER repeatedly to view all previous calibration data, starting from the first

range till fifth range. The meter will display the calibration value of that particular

range provided calibration is performed. If any of range is not being calibrated the

upper display shows “---“.

4. When you have scrolled through all calibration data, you will automatically return to

the SETUP main-menu P1.0. Press CAL/MEAS key if you wish to return to

measurement [MEAS] mode. Or to exit from viewing of any range in respective sub-

menus, press CAL/MEAS key reverts to the SETUP main-menu P1.0.

NOTE: If you enter into the setup mode from Conductivity measurement mode,

calibration data will be in µS or mS. Similarly if you enter into the setup mode from TDS

measurement mode, calibration data will be in ppm or ppt.

CAL

SETUP

CAL

SETUP

CAL

SETUP