User Guide

Instruction Manual CON 510

3.4 Connecting the Electrode Holder

The integral electrode holder serves as a handy holder for

a few electrodes or a separate temperature probe during

measurement or when not in use.

This bench meter’s base plate has a side metal bar to

which you can attach an integral swivel electrode holder.

You can mount the electrode holder on either right or left

side of the meter.

To position the electrode arm:

Use a Phillips screwdriver to remove the screw holding the

electrode holder. Slide the side metal bar until the second

screw slot lines up with the original screw hole. Use the

screw removed earlier to secure the electrode holder into

position. Note the side metal bar is reversible. If desired,

remove screw holding electrode holder base and slide out

of brackets, slide base into brackets on opposite side, and

tighten screw.

To install the electrode arm to the meter:

To mount the electrode arm into the metal rod on

the side bar, align the slot with the metal rod and

base of electrode arm. Push it downwards until it

fully sits into position. Avoid using excessive force

when fixing or removing. The electrode arm is ready

for use.

NOTE: Move the base of the electrode holder if you

wish to swing the electrode holder. To prevent the

meter from toppling over causing accidental spills,

DO NOT swing the body of the electrode holder.

Body of

Electrode

Holde

Side Metal Bar

Base of

Electrode

Holder