User Guide
Instruction Manual DO 100
20
8 SET FUNCTION
There are two setup parameters for each of the two measurement modes (% Saturation and
mg/L or ppm). This is due to the different properties associated with each unit of
measurement.
The SETUP function is a powerful feature that allows you to customise the meter to your
needs. For example you can choose to:
• Clear memory
• Adjust offset
• Input salinity value (in mg/L measurement mode)
• Choose different units of measurement for atmospheric pressure
(either in mm Hg or kPA) and adjust its value according to the
location
• Check for electrode’s calibration slope, offset and millivolt (mV)
value
• Change between mg/L or ppm measurement mode
• Activate or deactivate stabilising (READY) feature
• Activate or deactivate Power Auto-off feature
• Clear all parameters and reset the meter back to factory default
SET function will be explained in the following 2 sub-sections:
1. SET function in % Saturation measurement mode
2. SET function in mg/L or ppm measurement mode