User Guide

Instruction Manual DO 100

8.1.1 P 1.0: Clr

This clears all memory data input keyed during

measurement. Default setting is OFF.

1. Press SET key to enter the first level in its setup

menu.

2. Press MI/ or MR/ key to switch to “ON”.

3. Press ENTER key to confirm deleting all memory

data.

4. The meter will pause briefly and move on to the next

menu.

See Figure 17.

NOTE: Press HOLD key to skip this operation and

move on to the next menu, or press

CAL/MEAS key to exit setup menu to go

back to measurement mode.

NOTE: The data cleared relates to the input taken

while the meter was in % Saturation

measurement mode. To clear data input

in mg/L or ppm measurement mode, switch

the measurement mode to mg/L or ppm

and refer to Section 8.2.1 on page 31.

Figure 17: Clear Memory Menu