User Guide

Instruction Manual CyberScan pH 11 / 110

3.2 Connecting the pH Electrode Temperature Probe & Electrode

Holder

The pH 11/110 meter uses any standard pH, ORP, or Ion Selective Electrode (ISE)

with a BNC connector. For Automatic Temperature Compensation (ATC), this meter

requires a temperature probe with a phono-jack connector.

NOTE: It is important that water does not get into the BNC connector. Also avoid

touching the connector with soiled hands.

3.2.1 To connect pH, ORP or ISE electrode

1. Insert the BNC connector

from the electrode over the

BNC connector socket on the

meter.

2. Make sure the slots of the

connector are in line with the

posts of the socket.

3. Slide the BNC connector of

the electrode over (Figure 5).

4. Rotate the connector

clockwise until it locks.

5. To remove electrode, push

and rotate the connector

counterclockwise.

6. While holding onto the metal part of the connector, pull it away from the

meter.

7. Be careful not to use excessive force.

CAUTION: Do not pull on the probe cord or the probe wires might disconnect.

Refer to section 15 LIST OF ACCESSORIES section on page 65 for information on

temperature probe and other electrodes.

Figure 5: Insert the BNC connector from the

electrode cable into the BNC socket on the meter.