User Guide

Instruction Manual CyberScan pH 11 / 110
68
16 FACTORY DEFAULT SETTINGS
16.1 pH 11 Factory Default Settings
PROGRAM FUNCTION PARAMETER
OPTING KEYS
PARAMETER
OPTIONS
DEFAULT
SETTING
P 1.0 Unit Configuration Parameter Title
Only
Parameter Title
Only
P 1.1 Ready Indicator MI/▲; MR/▼ ON ; OFF, ON
P 1.2 Select pH buffer option MI/▲; MR/▼ USA, nSt, USA
P 1.3 Number of calibration
points
MI/▲; MR/▼ 3 P, 4 P, 5 P, 2 P 3 P
P 2.0 View previous calibration
data
Parameter Title
Only
Parameter Title
Only
P 2.1 First calibration point Viewing Only Viewing Only - - -
P 2.2 Second calibration point Viewing Only Viewing Only - - -
P 2.3 Third calibration point Viewing Only Viewing Only - - -
P 2.4 Fourth calibration point Viewing Only Viewing Only - - -
P 2.5 Fifth calibration point Viewing Only Viewing Only - - -
P 3.0 View electrode data Parameter Title
Only
Parameter Title
Only
P 3.1 Electrode offset (pH mode) Viewing only Viewing only - - -
P 3.2 pH electrode slope Viewing only Viewing only - - -
P 4.0 Select auto power on/off MI/▲; MR/▼ YES, nO YES
P 5.0 Reset to factory default Parameter Title
Only
Parameter Title
Only
P 5.1 Reset pH or ORP
calibrated data
MI/▲; MR/▼ nO, YES nO
P 5.2 User reset to factory
default
MI/▲; MR/▼ nO, YES nO
P 6.0 Memory clear MI/▲; MR/▼ nO, YES nO
NOTE: The HOLD/ENTER key is used to confirm every parameter opted. The
CAL/MEAS on the other hand will escape the set up operation to return to the
measurement mode.