Instruction manual

37
7.8 P6.0: Resetting to factory default settings
Available in pH 310 meter only
In the pH 310 meter, Program 6 lets you reset all parameters
to factory default settings. This clears all calibration data,
memory, and any other setup functions you might have
changed.
From measurement mode
1. Press SETUP key to enter Set Up mode.
2. Press the MI/▲ or MR/▼ keys to scroll through
subgroups until you view parameter P6.0.
3. Press the ENTER key to enter parameter P6.0.
4. Press the MI/▲ or MR/▼ keys to toggle between NO
and YES.
• ‘NO’ retains current settings
• ‘YES’ resets to factory default settings.
5. Press the ENTER key to confirm selection and to
return to the measurement mode. Otherwise press
CAL/MEAS key to return to measurement mode
without resetting to factory default.
See Figure 37.
Figure 37 - P6.0: Reset to factory
default values (pH 310 meter only)