Instruction manual

- 12 -
Mode Indicators
MEAS
Measurement mode; blinks in Symmetric mode
(Refer Section 3.1& 5.5 )
SETUP
Setup mode (Refer Section 5)
CAL
Calibration mode (Refer Section 4)
Status Annunciators
READY
Appears when the reading is stable
ATC
Appears when Automatic Temperature Compensation (ATC) is
enabled.
Not visible when Manual Temperature Compensation (MTC) is
enabled.
Flashes if the temperature probe is faulty in its ATC mode.
(Refer Section 5.3)
ERR
Appears when an error occurs (Eg. wrong key pressed)
Electrode annunciator. Appears when viewing electrode properties
or during calibration error
Buffer annunciator. Appears in calibration mode
Units of Measurement Indicators
mV
Millivolt. Appears in ORP measurement / calibration modes
(Refer Section 3.1, 4.4)
R.mV
Relative Millivolt
pH
Appears in pH measurement/calibration modes
(Refer Section 3.1,4.3)
ºC
Temperature in Celsius (Refer Section 5.3)
ºF
Temperature in Fahrenheit (Refer Section 5.3)