User's Manual

EUTRON Infosecurity - Key Solutions for IT Security Tel. +39 035 - 6970.80 Fax: + 39 035 - 6970.92
Via Gandhi 12 - I-24048 Treviolo (Bergamo) e-mail: info@eutron.com web: http://www.eutron.com
© Copyright 2006 by Eutron Infosecurity S.r.l.- Italy - 24048 Treviolo BG Via Gandhi, 12
© 2006 Eutron Infosecurity S.r.l. All rights reserved
The names of the other products mentioned are trademarks of their respective owners.
This hardware key is in compliance with the following test specification:
CEI EN 61000-4-2; CEI EN 61000-4-3; CISPR22
as required by:
CEI EN 61000-6-1, CEI EN 61000-6-2, CEI EN 61000-6-3, CEI EN 61000-6-4
which are specified for the following test:
“ESD Immunity test”
“Radiated radio-frequency and electromagnetic field immunity test”
“Radiated Emission Verification”
In compliance with the “Essential Requisites” for the EMC Directive 89/336/EEC.
FCC ID: TFC-AAD
EUTRON Infosecurity S.r.l.
CryptoCombo
(1)
Supply: 5V DC
Absorption: 250 mA
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1)
this device may not cause harmful interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or television reception,
which can be determined by turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
Caution: changes or modifications not expressly approved by the party responsible for compliance could
void the user's authority to operate the equipment.
1
The models subjected to this mark are the following: CryptoCombo ITSEC-I, CryptoCombo ITSEC-P and CryptoCombo
FIPS.