User's Manual

78
16 SmartKey Programming Central (SPC)
SmartKey Programming Central (SPC) can program SmartKey, i.e. input the data that determine the SmartKey's
configuration. The number of fields to be set varies according to the SmartKey model.
SPC makes it possible also to read the SmartKey configuration, modify it, save it on a file, restore it from a file and,
lastly, to write it on the SmartKey. The SPC window has two parts, as shown in Figure 10. The left part is for selecting
the SmartKey list you wish to configure. The right part is used for selecting one of the 10 panels for SmartKey
configuration.
If your SmartKey is not displayed, you can update the list with the Update push-button. If your SmartKey is still not
shown, this means that the system has not recognized it and the installation of the drivers must, therefore, be checked.
If the selected SmartKey is Fixed and, therefore, non-writable, the following panels are not shown: Programming,
Fixing, Contents and Reset Default. The first panel to use is Identification. It enables identification of the SmartKey and
access to the other panels. After identification, access to the panels is no longer subject to any constraint.
16.1 Identification panel
The SmartKey is identified by selecting the Identification panel and inputting the Label and Password values. The
values can be written either in text format or in hexadecimal format. You can select the two options with push-buttons
ASCII and Hex. If you are using a SmartKey, which still has the default values, you can avoid inputting these values by
selecting the Use default values option. The default values are: Label = SMARTKEY and Password = EUTRON.
Figure 10 shows an example of a computer containing a NET type SmartKey, whose drivers were correctly installed,
and with the Identification panel selected.
Figure 10
SmartKey identification panel
16.2 Info panel
If you select the Info panel, some information about SmartKey is displayed.
The following values are shown:
•
Model: type of SmartKey
•
Device: type of device used by SmartKey (USB or parallel)