Music Mixer User Manual

A 24V DC power source (i.e. a battery) has to be connected to the terminals (13) that are covered by a
protective lid. To reduce the risk of dropping voltage to a minimum and to eliminate the danger of damaging
Switching the amplifier on or off is performed through the power switch (6).
At all times, the amplifier has to be operated under appropriate conditions. This includes that the
the direct radiation or reflection from any heat source. Installing the loudspeaker systems choose a
operation location provided sufficient ventilation and the device is not exposed to direct sunlight or
also make sure that the speakers are installed at locations that are free from dust and / or moisture.
location that gets not affected by extreme and / or constant vibration or other mechanical oscillation.
INSTALLATION NOTES
CAUTION
DC POWER SUPPLY
the battery cables by thermal overload, these cables have to be at least 2.5mm in diameter, each
CONNECTING THE OUTPUT TERMINALS
CAUTION
The total impedance of the speakers connected must correspond to that selected on the amplifier's
Each speaker must be equipped with a line transformer with an input voltage equal to that of the line (25,
The length of the connecting cables must be as possible; in any case, the longer the distance to be
amplifier (i.e. total wattage of speakers installed in zones 1 through 5).
output terminals.
70, 100V).
covered and the greater must be the cross-section of the cables.
Constant impedance lines
Constant voltage lines
to these TERMINALS requires installation by an INSTRUCTED PERSON or the use of ready-made lead
TERMINALS marked with the symbol are HAZARDOUS LIVE and the external wiring connected
or cords to avoid the risk of electrical shock, the bare conductors leading to the outputnever touch
terminals of the amplifier when it is in operation. Under figures, show the possible connections of the
" OUTPUT" speaker terminals accessible by removing the protective cover. Bear in mind the following
The sum of the power capacities of the speakers must be no lower than the amplifier's power capacity.
The sum of the power capacities of the speakers must not exceed the output power capacity of the
CAUTION
AC POWER SUPPLY
This equipment operates from a power source that does not apply more than 244 VAC(r.m.s) between
conductors or between either supply conductor and ground.the supply
We strongly recommend that you leave the connection of the appliance to the qualified and
Do not take the risk of Electro-shock or shock hazard. To reduce the risk of Electro-shock, all connections
make certain that all connections are existing. The overall sound reinforcement installation has to be in
experienced service technician who is specialized in connecting electrical and electronically equipment.
carried out correctly and that no short-circuit connecting the appliance to the mains supply, once again
have to be accomplished before it is permissible to connect the amplifier to the main supply, Before
accordance to the laws, regulations, standards, and guidelines that are relevant and applicable in
CAUTION
the country where the equipment is going to be operated.
1
rules: