Owner`s manual

7. INSPECTION AND MAINTENANCE

7.5 MOVING ABOUT

 Switch off the power with power key before moving.

Always dismount from the scooter before moving.

 Lift the scooter by the chassis, and not by the shroud.

Lifting the scooter by the bumper could cause damage or injury.

 For your safety, always ask for help if required. You will need two people when

moving or lifting the scooter whole. If you are on your own, please disassembly the

scooter before lifting. Refer to the section below.

 Warning

Always unplug the rear section electrical connector before separating the two sections.

7.6 ASSEMBLING THE SCOOTER

 Suggestion

The assembly process is essentially the disassembly process in reverse. First study the

text and photographs in the disassembly procedure before re-assembling the scooter.

1. Loosen tiller adjustment knob, raise the tiller to the desired position, and then tighten the

tiller adjustment knob.

2. Reinstall the upper seat post at the desired height. Secure with the locking pin and tighten

the seat post knob.

3. Reinstall the batteries by lowering it in to place.

4. Replace the seat and rotate it until it locks into its correct position.

 Warning

After assembling the MiniRider, make absolutely certain the tiller adjustment knob is fully

tightened.