User manual

User Manual (Page 24 of 31)
6. INSPECTION AND MAINTENANCE
 Attention
１. When tread depth is below 0.5mm it can easily lead to vehicle slippage, making braking
distances longer, therefore, replace the tires as early as possible to prevent accidents.
２. The tire pressure shall be kept at about 35 PSI for the best ride and handling.
 Attention
When conducting maintenance of your vehicle, please turn the power switch to OFF and remove the
charger cords.
 Suggestions
 Do not splash water directly to wash your scooter as this could lead to malfunction of the system
electronics.
 Do not use gasoline, solvents or chemical solutions as these may deform or damage the shrouds.
 Do not use wax.
6.4 STORAGE
Make sure the vehicle is stored under the following conditions:
- Make sure the seat is set in the “Forward”position
- Make sure the power switch is turned to OFF
 Suggestion
Please store the scooter in a location where it is away from the direct sunlight, rain, or dew. When
storing for a long time, please charge the batteries fully and then disconnect the battery terminals.
For details contact your scooter dealer.
6.5 MOVING THE SCOOTER AROUND
 Turn the power switch “OFF” before moving it.
 Lift the scooter by the chassis, and not by the bumpers. Lifting the scooters by the bumper could
cause damage or injury.
 For your safety, always ask for help if required. You will need 2 or 3 persons when moving or lifting
this vehicle.
24 of 28