User manual

BATTERY & CHARGING INTRUCTION

Lead-Acid Battery

We recommend that you use deep-cycle batteries that are sealed and maintenance free for your power scooter.

Both sealed lead-acid (SLA) and gel cell are deep-cycle batteries and are similar in performance. Deep-cycle

batteries are specifically designed to provide power, drain down, and then accept a relatively quick recharge.

Specification of the battery that we recommend for

S34-FD TranSpor

t is

Type:

Size:

Voltage:

Amp Hours:

Deep –cycle sealed lead-acid or gel cell

12AH

12V each

12 amp hours

Depending on the use, terrain and driving conditions, the batteries will provide a range of

13 km

of travel.

However, even if the power scooter is not in use, we recommend that the

batteries are charged periodically.

Note: Do not use any automotive batteries. They are not designed to handle a long, deep discharge and also are

unsafe for use in power scooter. The useful life of a battery is quite often a reflection of the care it receives.

BATTERY CHARGER

The battery charger takes the standard wall outlet voltage (alternating current) and converts it into DC voltage

(direct current).The batteries use direct current to run your power scooter. When the batteries are fully charged,

the amperage from the charger is almost at zero. This is how the charger maintains a charge but does not

overcharge the battery.

Note 1: The batteries cannot be charged if they were discharged to nearly zero voltage.

Note 2: The powered scooter meet the requirement of ISO 7176-14:2008 and ISO 7176-21:2003.

Note 3: Only use the battery charger type 4C24050A which was provided by the scooter supplier. The use of

any different type of charger can be hazardous and need the approval of the manufacturer.

CHARGING INSTRUCTIONS

To recharge the batteries, follow the steps below:

Ö Place your power scooter close to a standard electrical wall outlet.

Ö Remove your key to turn the power OFF

Ö Slide the charger port door open.

Ö Plug the XLR connector of the charger to the charger port.

Ö Plug the other end of power cord into a standard wall outlet.

Ö When charging is completed, battery capacity indicator is shown.

Ö Disconnect the charger power cord from the wall outlet when the batteries are fully charged.

Recharge battery only when the key is in off position. When indicator is in low status, this confirms the battery

needs recharging.