Data Sheet

Attaching the truss clamp to the bracket
The truss clamp illustration shows vertical adjustment 1.
To attach the truss clamp to the bracket, do the following:
1. Remove the bolt and washer (supplied) from the truss clamp.
Save the bolt and washer.
2. Align the truss clamp (A) with the desired vertical adjustment.
Figure 2.9: Truss clamp and bracket
3. Insert the bolt and washer (B) through the truss bracket into the truss clamp.
Use the bolt and washer removed from step 1.
4. Tighten the bolt (B).
The truss clamp is secured to the bracket.
Attaching the truss adapter
Use the correct size truss adapter designed for your EKX-12, EKX-15, EKX-12P, or EKX-15P full-
range loudspeaker loudspeaker. The EKX-15 loudspeaker is shown in the illustrations with the
truss adapter in vertical adjustment 1. For more information, see EKX Full-Range Loudspeaker
Accessory Guide, page 7 and Vertical adjustment of the truss clamp, page 12.
To attach the truss adaptor to the EKX-12, EKX-15, EKX-12P, or EKX-15P loudspeaker, do
the following:
1. Using the L-Key (supplied), remove three (3) M10 screws from the top of the
loudspeaker.
Figure 2.10: Removing screws
2. Align the holes on the bracket fitting the loudspeaker size.
en 13
Electro-Voice Installation Note 2015.03 | 01 | F.01U.308.107