Data Sheet

Attaching the T-Brackets
Use the correct size wall mount bracket kit designed for your EKX-12, EKX-15, EKX-12P or
EKX-15P full-range loudspeaker. The EKX-15 loudspeaker is shown in the illustrations. For
more information, see EKX Full-Range Loudspeaker Accessory Guide, page 7.
To attach the T-Brackets to EKX-12, EKX-15, EKX-12P, or EKX-15P loudspeaker, do the
following:
1. Using an Allen wrench (supplied), remove the four (4) rear suspension point M10 screws
from the loudspeaker.
Figure 2.1: Removing screws
2. Align the T-Bracket with the holes on the top and rear of the loudspeaker (Vertical).
OR
Align the T-Bracket with the holes on the right and rear of the loudspeaker (Horizontal).
Notice!
When mounting a loudspeaker horizontally, the T-Bracket with hook needs to be installed on
the left side as you face the front of the loudspeaker.
Figure 2.2: T-Brackets Vertical (left) Horizontal (right)
3. Insert two (2) of the M10 button head screws, two (2) M10 split lock washers, and two
(2) M10 flat washers (supplied).
4. Tighten the two (2) M10 button head screws.
The T-bracket is secured to the loudspeaker.
EKX Full-Range Loudspeaker Accessories
2015.03 | 01 | F.01U.308.107 Installation Note Electro-Voice