Data Sheet

Attaching the array bracket
To attach the array bracket to the ETX-35P loudspeakers, do the following:
1. Place two (2) ETX-35P loudspeakers on the floor with the amplifiers facing you.
2. Using the L-Key (supplied), remove the two (2) inside suspension point M10 screws (A)
from the top of both loudspeakers.
A
B
Figure 2.17: Remove screws
3. Remove the two (2) back suspension point M10 screws (B) from the top of both
loudspeakers.
4. Align the front of the top bracket with the inside suspension points.
The front of the top bracket is shorter than the back of the top bracket.
Front
(shorter)
Back
(longer)
Figure 2.18: Align top bracket
5. Align the back of the top bracket with the back suspension points.
The back of the top bracket is longer than the front of the top bracket.
ETX Powered Loudspeaker Accessories
2014.09 | 03 | F.01U.299.895 Installation Guide Electro-Voice