Data Sheet

Attaching the T-Brackets
The ETX-12P loudspeaker is shown in the illustrations. Use the correct size wall mount bracket
kit designed for your ETX-10P, ETX-12P, or ETX-15P loudspeaker. For more information, see
ETX Powered Loudspeakers Accessory Guide, page 6.
To attach the T-Brackets to ETX-10P, ETX-12P, or ETX-15P loudspeaker, do the following:
1. Using an Allen wrench (supplied), remove the four (4) rear suspension point M10 screws
from the loudspeaker.
Figure 2.1: Removing screws
2. Align the T-Bracket with the holes on the top and rear of the loudspeaker (Vertical).
OR
Align the T-Bracket with the holes on the right and rear of the loudspeaker (Horizontal).
Notice!
When mounting a loudspeaker horizontally, the T-Bracket with hook needs to be installed on
the left side as you face the front of the loudspeaker.
T-Bracket
with hook
T-Bracket
T-Bracket
with hook
Figure 2.2: T-Brackets Vertical (left) Horizontal (right)
3. Insert two (2) of the M10 button head screws, two (2) M10 flat washers, and two (2)
M10 split lock washers (supplied).
4. Tighten the two (2) M10 button head screws.
The T-bracket is secured to the loudspeaker.
en 7
Electro-Voice Installation Guide 2014.09 | 03 | F.01U.299.895