Data Sheet

5. Align the T-Bracket with hook with the holes on the bottom and rear of the loudspeaker
(Vertical).
OR
Align the T-Bracket with hook with the holes on the left and rear of the loudspeaker
(Horizontal).
Notice!
When mounting a loudspeaker horizontally, the T-Bracket with the hook needs to be installed
on the left side as you face the front of the loudspeaker.
6. Insert two (2) of the M10 button head screws, two (2) M10 flat washers, and two (2)
M10 split lock washers (supplied).
7. Tighten the two (2) M10 button head screws.
The T-bracket with hook is secured to the loudspeaker.
Mounting U-Bracket to the wall
The wall mount U-Bracket is used to mount a loudspeaker to the wall.
!
Caution!
Due to the weight of the Electro-Voice loudspeaker system, it is imperative the bracket is
properly secured to the wall. The choice of fastener (not supplied) will be determined by the
material and construction of the mounting surface. The user is responsible to ensure the
mounting surface and fasteners are capable of supporting the weight of the loudspeaker.
!
Caution!
Two (2) person lift and placement is recommended for the heavier loudspeakers. Single
person lift and placement of heavier loudspeakers could cause injury.
Notice!
The wall U-Bracket mounting holes accept M10 or 3/8-inch fasteners. The horizontal holes are
located 16-inches apart for attachment to studs.
ETX Powered Loudspeaker Accessories
2014.09 | 03 | F.01U.299.895 Installation Guide Electro-Voice