Users Manual

ZW34 Double Switch

FEATURES:

• Manual or Z-Wave control of 2 separate loads (dimmer+ relay)

• Perfect replacement for a fan / light combo (neut「al wire required)

• Scene control for multi-tap scenarios on select hubs

• Quick and easy pigtail wire installation (single pole only)

• 4-color LED indicator and air-gap switch for added safety

• Packed with advanced dimming features including ramp rate control, custom on brightness level, and double

tap to full brightness

• Remembers and restores on/off status after power failure

• Built-in Z-Wave Plus signal repeater to extend network range

• S2 security protocol and 500 Z-Wave chip

SPECIFICATIONS:

• Z-Wave Signal Frequency: 908.42 MHz

• Power: 120 VAC, 60 Hz

• Dimmer Max Load: 75 W LED 250 W incandescent; DON'T use with tube lights, DC powered fixtures, or

chandeliers

• Relay Max Load: 15A (1/2 HP)

• Operating Temperature: 32-104° F(0-40° C)

• Installation and Use: Indoor only

PAGE 1
ZW34 Double Switch FEATURES: • Manual or Z-Wave control of 2 separate loads (dimmer+ relay) • Perfect replacement for a fan / light combo (neut「al wire required) • Scene control for multi-tap scenarios on select hubs • Quick and easy pigtail wire installation (single pole only) • 4-color LED indicator and air-gap switch for added safety • Packed with advanced dimming features including ramp rate control, custom on brightness level, and double tap to full brightness • Remembers and restores on/off status aft
PAGE 2
FCC Caution. This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Any Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.