FCC ID: 2AQURZW34
Introduction: This product can be operated in any Z-Wave network with other Z-Wave certified devices from other manufacturers. All non-battery operated nodes within the network will act as repeaters regardless of vendor to increase reliability of the network. Each module is designed to act as a repeater,which will re-transmit a radio frequency (RF) signal by routing the signal around obstacles and radio dead spots to ensure that the signal is received at its intended destination.
Z-Wave MULTI_CHANNEL ZW34 is multi channel device,It has two endpoints. Dimmer is Endpoint1, Relay is Endpoint2.
Z-Wave Configuration Parameters You may use the below configuration parameters to change settings of the corresponding functionality.
17: when switch is on or off and quickly press UPPER paddle 2 times, switch turns on to x brightness Paramter No: 17(0x11) Size:1 Byte Value: 00 turn on to 99(default) Value: 01 turn on to the value relate with parameter 15 18: Double Tap Behavior Paramter No: 18(0x12) Size:1 Byte (default 00) Value: 00 enable double tap to full brightness, single tap to last brightness level or custom value set in parameter 23 Value: 01 disable double tap to full brightness, single tap to last brightness level or custom va