Manual

TRAVELMATE
Instruction Manual
4 |
P a g e
• SETTING THE TEMPERATURE: Press SET once and then the display will flash then
press the + and - buttons to adjust the temperature. Press the button + to increase and the
button - to decrease the temperature. To lock in the target temperature press SET three times.
The display board will display the current temperature inside the unit after the target
temperature is set. After approximately 5 minutes the displayed temperature will start to
decrease.
• Temperature setting range -20ºC +10ºC, -4ºF +50ºF
• If the power supply is cut off, the refrigerator will switch off automatically and then
automatically switch on again when the unit receives power.
• To change the fridge between ºC and ºF. Press SET twice and then + or - to change the
setting. Press SET twice to lock this in.
• CHANGING BATTERY VOLTAGE PROTECTION: To change the battery voltage
setting press the SET button three times and then use the + or - to change the setting.
Press SET once to lock this in. The three voltage settings are as follows :-
(Evakool recommends you keep the setting on LO)
o LO – 10.4 Volts
o NE – 11.2 Volts
o HI – 12 Volts
USB Charging Port and Thermostat Override Switch
 USB Port – This USB port can be used to charge small devices. E.g. mobile phones and remote
controllers. The socket is rated to 500mA / 5 Volts.
 Thermostat Override switch – If your digital thermostat fails and you are unable to set the
temperature, turn this switch to Emergency override. This enables the fridge to run until you reach a
service centre to replace the faulty component.
o If emergency override is enabled the compressor will attempt to run 100% of the time. As this
removed the ability to set the internal temperature and will increase power usage (Total
consumption), it is not recommended for everyday use.