Blizzard S10 User instruction manual Fill pressure: 200 bar (approximately 2,900 psi)
Contents Rules of safe shooting ................................... 3 Filling the rifle .............................................. 4 Loading the rifle ........................................... 5 Adjusting the trigger ..................................... 6 Safety ........................................................... 7 Maintenance tips .......................................... 8 Troubleshooting............................................ 8 Warranty ...............................................
Rules of safe shooting • Never point a gun at anyone or anything, even if you think the gun is unloaded. • Wear shooting/safety glasses where appropriate and ensure those around you do too. • Always keep your gun on SAFE until you are ready to shoot safely. • Always use a safe backstop in a safe location in case the backstop should fail or any pellets pass through it. • Never load your gun until you are ready to shoot and it is safe to do so.
Filling the rifle 1) Attach the stainless steel fill adapter to the correct fill equipment. Rotate the fill port’s protective cover to allow access. Insert the fill adapter into the fill port. Do not use any other type of adapter other than the one supplied with the rifle. Slowly fill the rifle to a MAXIMUM of 200 bar (approximately 2,900 psi) pressure. Filling the rifle too fast is unsafe and creates excess heat that may result in a low or inaccurate fill pressure.
Loading the rifle Note: Your Evanix Blizzard S10 does not come with open sights. You must mount an optical device (e.g., scope, dot sight, etc.) before use. Use a good quality mount to ensure best accuracy and proper alignment. To remove the magazine, pull the sidelever back to its rearmost position. The magazine can now be removed from the rifle.
Adjusting the trigger Make sure the rifle is unloaded by removing the magazine and ensure there are no pellets in the breech. Put the gun on SAFE. Invert the rifle and secure it in a rifle stand or similar stabilizing device. Remove the stock. First-stage adjustment The adjustment screw for the first stage is situated in the section underneath the trigger blade. Using a 1.5mm Allen key, turn the screw clockwise to decrease the amount of first-stage travel.
Safety To activate the safety, push the safety catch lever rearward to the S position. When the safety is engaged, the trigger is locked and the rifle cannot be fired. To disengage the safety and fire the rifle, push the safety lever forward to the F position. In addition to the safety catch, a loaded and cocked rifle can be made safe by decocking (uncocking). To decock the rifle, first pull the sidelever back to the rear position and remove the magazine.
Maintenance tips Clean your rifle's exterior with a good-quality silicone product. Apply the silicone to a lintfree cloth and then wipe down the rifle's exterior. Do NOT leave the air filler hole exposed. Always rotate the protective cover when not filling the gun with air. Do NOT rely solely on the safety to provide guaranteed safety. YOU are the ultimate safety for your gun. Do NOT leave pellets loaded in the breech of the rifle. Always remove the magazine from the rifle when you are done shooting.
Warranty One-Year Limited Warranty This product is warranted to the retail consumer for one year from date of retail purchase against defects in material and workmanship and is transferable. What is covered: Replacement parts and labor. Transportation charges to consumer for repaired product. What is NOT covered: • Transportation charges to Air Venturi for defective products. • Damages caused by abuse or failure to perform normal maintenance. • Any other expense. • Parts subject to normal wear and tear.
WARNINGS: Not a toy. Adult supervision required. Misuse or careless use may cause serious injury or death. May be dangerous up to 1,000 yards. This airgun is intended for use by those 18 years of age or older. Do not inhale dust from lead pellets or put lead pellets in the mouth. Wash hands after handling lead. Lead pellets contain lead, a chemical known to the State of California to cause cancer and birth defects (or other reproductive harm). Use only dry, filtered compressed air in this gun.
Warranty registration Evanix rifles are manufactured to the highest possible standards, using the finest materials to give a lifetime of service. In the unlikely event of there being any defects in materials or workmanship in the first twelve (12) months after retail purchase, we will repair or replace the rifle under warranty. Note—The warranty will be invalid if: • The rifle has been disassembled and incorrectly reassembled. • The rifle is found to have lubrication not recommended by Evanix.
336U Air Venturi 18370 South Miles Warrensville Heights, OH 44128 216-220-1180 • fax 216-373-0086 Copyright ©2010 Air Venturi. All rights reserved.