User Manual

In order to remove the water instantly from the internal reservoir and prepare device for transportation,
please do the following:
1. Disconnect the device from a power source.
2. Remove the reservoir by sliding it up.
3. Use both hands to lift the upper part of the body. Push on both sides of its bottom part to release the
locks and then slide it upwards.
4. Tilt the device to the right while holding the cartridge and drain the water carefully.
5. Put the upper lid of the body back so that it ts the slots.
6. Put the reservoir back in place.
7. The device is ready for transportation.
Important: Even if there is no water in the internal reservoir, the evaporative cartridge could still be wet.
Do not transport the device with the wet cartridge for a long time. Please see section “Storage during
long periods of no usage” For short transportations make sure that the device with wet cartridge is not
isolated in a box or bag with no air ow.
1. 2. 3.
4. 5. 6. 7.
6.