User Manual

• After completing the wiring steps, reconnect the charging cable following the steps listed

above in reverse order.

• Figure below shows how the charge cable looks after reconnecting all the cables.

Tips and tricks for easy install

In certain cases, installation can be simplied if the charging cable is removed. The following

are steps to remove the charging cable.

• Unscrew the blue and the brown cables form the contactor labeled T1 and T2 (see below).

• Unplug the yellow/green ground wire from the spring clamp.

• Unplug the thin red wire (pilot signal).

• Unscrew the wire gland at the bottom.

• Pull the charge cable out.