Manual

C-PRO KILO HARDWARE MANUAL
Page 47
6.4 Control and monitoring accessories
These modules allow the conversion of signals from TTL to RS-485 (with or without optoisolation) for control
by means of the MODBUS protocol.
The modules are connected to the specific AMP Micro-match 6 pin connector located on the controller; this
connector is shared with the parameter programming key and the tools for programming the controller flash
memory.
6.4.1 Non-optoisolated TTL/RS-485 interface
EVIF20TSX
Non-optoisolated TTL/RS-485 interface
6.4.2 Optoisolated TTL/RS-485 interface
EVIF21TS7I
Optoisolated TTL/RS-485 interface