Instruction Manual

EVCO S.p.A. EVBOX1 | Installation guide ver. 1.2 | Code 144BOX1E124
page 58 of 88
i5 0 9 - - - - 7 7 7 7 7 7 7 7
6
= ACTIVATION OF THE MINIMUM PRESSURE
SWITCH ALARM - the compressor will be switched
off, the display will show the flashing code “LP” and the buzzer will be activated (until the input is deactivated); if u1 and/or u11 = 10, the compressor will be switched off after the pump down valve has switched off (also look at C14 and i17)
7
= COMPRESSOR THERMAL PROTECTION - the
compressor will be switched off, the display will show the flashing code “C1t” and the buzzer will be activated (until the input is deactivated)
8
= COMPRESSOR 2 THERMAL PROTECTION - the
compressor 2 will be switched off (only if u1 and/or u11 = 7), the display will show the flashing code “C2t” and the buzzer will be activated (until
the input is deactivated)
9
= MAN IN COLD ROOM ALARM ACTIVATION - the
man in cold room output shall be turned on (only if u1 and/or u11 = 12), the display will show the flashing code “MiC” and the buzzer will be
activated (until the input is deactivated)
i6 0 1 - - - - 0 0 0 0 0 0 0 0
type of multifunction input contact 0 = normally open (active input with closed contact)
1
= normally closed (active input with open contact)
i7 0 120 min 0 0 0 0 0 0 0 0
if i5 and/or i15 = 2, multifunction input alarm delay (code “iA”) if i5 and/or i15 = 3, delay in compressor switching on after the deactivation of the multifunction input (34)