Instruction Manual

EVCO S.p.A. EVBOX1 | Installation guide ver. 1.2 | Code 144BOX1E124

page 61 of 88

i15 0 9 - - - - 9 9 9 9 9 9 9 9

= ACTIVATION OF THE MINIMUM PRESSURE

SWITCH ALARM - the compressor will be switched

off, the display will show the flashing code “LP”

and the buzzer will be activated (until the input is

deactivated); if u1 and/or u11 = 10, the

compressor will be switched off after the switching

off of the pump down valve (also look at C14 and

i17)

= COMPRESSOR THERMAL PROTECTION - the

compressor will be switched off, the display will

show the flashing code “C1t” and the buzzer will

be activated (until the input is deactivated)

= COMPRESSOR 2 THERMAL PROTECTION - the

compressor will 2 be switched off (only if u1

and/or

u11 = 7), the display will show the flashing code

“C2t” and the buzzer will be activated (until the

input is deactivated)

9 = MAN IN COLD ROOM ALARM ACTIVATION - the

man in cold room output shall be turned on (only

if u1 and/or u11 = 12), the display will show the

flashing code “MiC” and the buzzer will be

activated (until the input is deactivated)

i16 0 1 - - - - 0 0 0 0 0 0 0 0

type of multifunction 2 input contact

0 = normally open (active input with closed contact)

= normally closed (active input with open contact)

i17 0 240 s 30 30 30 30 30 30 30 30

minimum pressure switch alarm delay after the

compressor switches on (code “LP”)