Manual

EVCO S.p.A. Vcolor 818 | Installer manual ver. 1.1 | Code 144VC818E114
page 60 of 94
11.3 Restoring the factory settings
11.3.1 Access to the procedure
Operate as follows:
1. Make sure that the instrument is in the “stand-by” status.
2. Make sure that the keyboard is not locked and that no procedure is in progress.
3. Press and release the top right corner of the screen (1).
Note:
Prj692AA05, represents the identifier of the keyboard firmware
Prj689AA05, represents the identifier of the base station firmware for power
11.3.2 Restoring the configuration parameters
Operate as follows:
1. Access to the; see paragraph 11.3.1 “Access to the procedure”.
2. Repeatedly press and release the + key (1) to set “149” and then press and release the SET key (2).
Operate as follows to exit the procedure:
3. Press and release the ESCAPE key or do not operate for 60 s.